Comtrol NS-link Windows NT User Manual download pdf (Page 11)

100

Overview 11

DeviceMaster PRO LEDs

DeviceMaster PRO

LEDs

Use this table to verify that your DeviceMaster PRO is ready for NS-Link

installation.

RocketPort Serial

Hub ia LEDs

Use this table to verify that your RocketPort Serial Hub ia is ready for NS-Link

installation.

RocketPort Serial

Hub Si LEDs

Use this table to verify that your RocketPort Serial Hub Si is ready for NS-Link

installation.

Model How to tell if the DeviceMaster PRO is working properly:

DeviceMaster

PRO 8

•The PWR LED on the front of the unit is lit, which indicates

it has power and has completed the boot cycle.

Note: The PWR LED flashes while booting and it takes

approximately 15 seconds for the bootloader to

complete the cycle.

•The red LNK/ACT LED is lit, which indicates a working

Ethernet connection.

•If the red 100 LED is lit, it indicates a working 100 MB

Ethernet connection (100 MB network, only).

DeviceMaster

PRO 16

•The Status LED on the front of the unit is lit, which indicates

it has power and has completed the boot cycle.

Note: The Status LED flashes while booting and it takes

approximately 15 seconds for the bootloader to

complete the cycle.

•The red LNK/ACT LED is lit, which indicates a working

Ethernet connection.

•If the red Duplex LED is lit, it indicates full-duplex activity.

•If the red 100 LED is lit, it indicates a working 100 MB

Ethernet connection (100 MB network, only).

Model

How to tell if the RocketPort Serial Hub ia is working

properly:

RocketPort

Serial Hub ia

• The yellow PWR LED is flashing, which means that the

device is waiting for the driver installation.

Note: If the PWR LED is lit steady with only an occasional

flash, it means that the device driver has loaded.

• The green LNK LED is lit, which indicates a working

Ethernet connection.

• The yellow ACT LED flashes, which indicates Ethernet

activity on the network.

Model

How to tell if the RocketPort Serial Hub Si is working

properly:

RocketPort

Serial Hub Si

2-port

•The Power LED in the front of the unit is flashing, which

indicates that the device is waiting for the driver

installation.

Note: If the Power LED is lit steady with only an occasional

flash, it means that the device driver has loaded.

•Both

10/100BASE-T LEDs are lit, which indicates a working

Ethernet connection.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 99 100

Comments to this Manuals

No comments

Comtrol NS-link Windows NT User Manual Page 11

Comments to this Manuals

Related products and manuals for Software Comtrol NS-link Windows NT